Description

Listed is an A5 sheet with several Raptors icons Please note that some of the icons may not have printed fully and there could be white markings on them which should be able to be painted over if not there are more than enough symbols to use These were printed on white decal paper and you need to cut around the icon as close as possible around the colour to get them onto the shoulders otherwise the film will be too big I also recommend using the Microsol and Microset method. Or you can paint over the white with black once the decal is sealed in. Directions for use: 1) When the model area is painted in the matching colour to these gloss varnish the area you'd like the transfer. 2) Allow to dry fully 3) Cut around the decal as close as you possibly can around the coloured edge 4) Dampen the decal for a few seconds then slide the decal carefully with a brush onto the area 5) Allow to dry 6) Apply very thin coats of Microset and Then Microsol multiple times allowing to dry between each coat (Use an old brush) 7) When the decal is set and has no wrinkles or bubbles paint around the edge with the matching paint colour 8) Gloss varnish the model area one more time 9) Add battle damage with the matching base colour if desired. 10) Seal in the transfer (And or whole model) with your desired finish, Matt, Satin or Gloss. I have attached an example of a Black Consul Marine using this process with one of my own decals and black paint. The dark red squares are closely matched as possible to citadels Death world forest If you would like battleline markings in the matching colour for these or any other colour or are interested in a different chapter please message me and I might be able to help! If you have any questions please ask The icons and approximate sizes included are 5mm x 4mm x 105 6mm x 4.7mm - 78 7mm x 5.5mm - 60 10mm x 7.9mm - 15 12mm x 9.5mm - 6